- Fri Dec 04, 2015 9:56 pm
#35689
If you want to reactivate the ceramic antenna in the future, you only need to put a blob of solder on those pads ...
- Wed Dec 16, 2015 12:39 am
#36547
Greetings!! would you guys be kind enough to confirm if I am going to remove the correct cap from the board? the first component that is between the external antenna port and the rectangular board antenna. Thanks in advanced.
- Wed Dec 16, 2015 3:37 pm
#36612
I can confirm you should read the whole thread
For instance this message and the one that follows: viewtopic.php?f=6&t=1550&start=12#p35599
El Torote wrote:Greetings!! would you guys be kind enough to confirm if I am going to remove the correct cap from the board? the first component that is between the external antenna port and the rectangular board antenna. Thanks in advanced.
I can confirm you should read the whole thread
For instance this message and the one that follows: viewtopic.php?f=6&t=1550&start=12#p35599
- Fri Sep 02, 2016 1:24 pm
#54330
Hi all,
I removed the stated resistor,
it is still connecting to internet and uploading data online.
I think the ceramic antenna is not disconnected.
What should I do to disconnect it?
I only need an external antenna slot.
I removed the stated resistor,
it is still connecting to internet and uploading data online.
I think the ceramic antenna is not disconnected.
What should I do to disconnect it?
I only need an external antenna slot.
