ESP8266 Community Forum

- Wed Dec 09, 2015 3:54 pm #36083 Hi,
Is there any help.
I checked the wiring with Putty and AT Commands. This worked. Also a SSID-Network Scan.
Then I run the ESP_Basic_Flasher.exe succesfully.
After a reboot (unplug FTDI-USB) and release GPIO0 only the red LED is on.
If if ground GPIO2 the blue LED is on.
But in both cases there is no WLAN activity. No "ESP" visible.
What is goining wrong?
Best regards,
ingmar

- Wed Dec 09, 2015 5:59 pm #36103 Check your serial terminal for any msgs.

Set your baud speed for 9600.

This might not be the right section of the forum for esp8266 Basic questions.

Serial terminal in the chrome browser see https://serialTerminal.com

http://esp8266basic.com
A BASIC interpreter for your ESP

Working now on Autodrop3d. A 3d printer with automatic part ejection system. https://autodrop3d.com

- Tue Dec 15, 2015 4:38 am #36461 Moved to Basic forums

- Tue Dec 15, 2015 10:01 pm #36539 I have the same problem, no "ESP" AP is available. After rebooting the board, I can see the following in a serial terminal:

--
ESP Basic 1.65
1
2
3
Connected to
IP address : 10.0.1.10
WIFIname
WIFIpass
Starting Default Program
Done...
--

Any suggestions?