- Sat Dec 26, 2015 2:21 pm
#37178
Here is a cheap I2S DAC with connectors.......
http://www.banggood.com/DC-5V-10V-I2S-Player-32-Bit-384K-PCM5102-DAC-Decoder-Board-p-1019103.html
http://www.banggood.com/DC-5V-10V-I2S-Player-32-Bit-384K-PCM5102-DAC-Decoder-Board-p-1019103.html
- Sun Dec 27, 2015 1:42 pm
#37254
Deep in this thread I2S input was questioned. HAs anyone seen any support of I2S input yet? Would really help on a project where I'm sampling audio with an I2S microphone.
- Fri Jan 08, 2016 4:12 pm
#38229
Hello,
i posted that i've tested the pvvx version over several hours on the ESP-01 without problems. Now i have flashed the same binaries to an esp-12E module with 4MB flash (nodemcu 1.0?) and i can hear only a few seconds to the music, then nothing for about a minute -> one second music -> 1min nothing ...
should i change something before compiling it, to run the code one the 4MB version as good as on ESP-01?
EDIT: i restarted my FRITZ!Box Wifi Router and everything is fine -> works great! Thanks again!
i posted that i've tested the pvvx version over several hours on the ESP-01 without problems. Now i have flashed the same binaries to an esp-12E module with 4MB flash (nodemcu 1.0?) and i can hear only a few seconds to the music, then nothing for about a minute -> one second music -> 1min nothing ...
should i change something before compiling it, to run the code one the 4MB version as good as on ESP-01?
EDIT: i restarted my FRITZ!Box Wifi Router and everything is fine -> works great! Thanks again!
