ESP8266 Community Forum

- Wed Dec 03, 2014 5:57 am #3907 Hi All,

I added two new AT commands to get the module to get the time from NTP servers (pool.ntp.org), I used SDK version 0.9.3 and AT commands version 20 as starting point.

AT+CIPNTP=<offset from GMT> , to initialize the ntp, and start syncing the time - for example: AT+CIPNTP=2 to intialize it with GMT+2 offset.
AT+CIPNTP? - to get the current time, for example:

AT+CIPNTP?
Time: 22:22:42 12/02/2014 GMT+02

Firmware and SDK can be downloaded from http://bit.ly/esp8266-ntp.

Source code can be retrieved from https://github.com/TomerCo/ESP8266-AT

Update: binaries compiled with SDK 0.9.4 can be found at http://bit.ly/esp8266-ntp0-9-4

Comments / Suggestions are welcome.

Last edited by Tomer on Wed Dec 24, 2014 3:21 pm, edited 4 times in total.

- Wed Dec 03, 2014 6:21 am #3911 can you share source code?

ESP8266.com Moderator
Lets get the party started and +1

[url=https://www.banggood.com/custlink/KvGGhGF4wG[/url]

I like ESP8266 and ESP8285 and ESP32

- Wed Dec 03, 2014 6:48 am #3914 Yes, I will share it today or tomorrow, just need to setup github/bitbucket/whatever

- Wed Dec 03, 2014 6:54 am #3915

Yes, I will share it today or tomorrow, just need to setup github/bitbucket/whatever

i preffer github this is nice work.

ESP8266.com Moderator
Lets get the party started and +1

[url=https://www.banggood.com/custlink/KvGGhGF4wG[/url]

I like ESP8266 and ESP8285 and ESP32