General area when it fits no where else

Moderator: Mmiscool

User avatar
By viscomjim
#39408 Just loaded Mikes basic on this little bad boy...

https://www.itead.cc/smart-home/sonoff- ... witch.html

Works great. Will play with code a bit and post more data.

Relay is on gpio 12, and green led is on gpio 13. - This unit does not have the RF control with key fob, but for $5, you CAN NOT BEAT THIS!!!! Has nice little power supply for AC and relay control.

Might have to flash the led to spit out the ip address once connected to your network, or something.... or just leave it as AP.
User avatar
By Mmiscool
#39476 This is great. Can you provide some details and pictures of how you wired the device to be programmed. I might have to buy a few of them for some of my own projects.
User avatar
By mianos
#39477 Just check the photo on the page. The TTL serial are labelled. They go gnd, tx, rx and +3.5V. The button is on GPIO0 so you just hold it down to flash it. I have the first version and just used a normal $4 USB to serial port board, making sure it only has 3.5V output (not 5).