Need help with generic ESP8266 module

Your new topic does not fit any of the above??? Check first. Then post here. Thanks.

Moderator: igrr

 Reply

User avatar

Re: Need help with generic ESP8266 module

By minils
- Fri Jan 29, 2016 10:08 am #39945
schufti wrote:yes, but with the multimeter you can't see if the magnetometer pulls gpio2 low on power-up and/or reset ...

disconnect the magnetometer and see if the ESP starts ok

I removed the magnetometer from the PCB, but the problem remains.

Do you think it could be that the flash is not correctly connected?
User avatar

Re: Need help with generic ESP8266 module

By minils
- Sun Jan 31, 2016 5:53 am #40055
schufti wrote:Did you allready set baudrate of your terminal-sw to 74880 and see what the bootloader has to say?

Thank you very much! I didn't know about this.
I tried it and figured out that the ESP is constantly restarting. The reset cause is 2 which as far as i know stands for reset pin.
 Reply
Return to General Discussions