Chat freely about anything...

User avatar
By Barnabybear
#40381 Hi, if I had to guess & it is only a guess (the PDF data sheet was 1000+ pages) , I would think its to do with pull up resistors on the outputs. Try 10K pull up on Tx & Rx see how you go.
User avatar
By martinayotte
#41721 The blue signal looks strange, it is like it is shorted by some other HIGH signal, preventing it to deliver at true LOW state during the first 75% of the transmission.
Check the wiring again !
Try to measure it again while disconnected to figure out which side is doing that kind of short.