- Mon May 02, 2016 11:57 am
#46706
Are you sure of your wiring ?
How the GPIO2/GPIO0/CH_PD pins are wired ?
How the GPIO2/GPIO0/CH_PD pins are wired ?
Moderator: igrr
- Mon May 02, 2016 1:02 pm
#46717
I'm using the following typical scheme:
USB-TTL convertor is CP2102.
As I've mentioned earlier, ESPlorer can grab serial output even with my current wiring, but I wish to continue development in Arduino IDE and I'm already tired to switch between programs.
USB-TTL convertor is CP2102.
As I've mentioned earlier, ESPlorer can grab serial output even with my current wiring, but I wish to continue development in Arduino IDE and I'm already tired to switch between programs.
- Tue May 03, 2016 1:17 pm
#46802
most likely the two systems handle handshake lines differrently. In Arduino IDE it depends a lot on the board setting. With "generic ESP8266" you have to disconnect (at least I do) RTS & DTR to run your sketch with this cabling.
