- Wed Jun 08, 2016 4:23 am
#48755
No messages at all, not even gibberish from wrong baud rate.
Moderator: Mmiscool
- Wed Jun 08, 2016 5:08 pm
#48814
I got it to work. No idea what I was doing wrong earlier. I guess that's what happens when you stay up too late. V3.0 Alpha 5 works great on this board, serial port working at 9600baud
- Fri Jun 10, 2016 3:35 am
#48921
Hi russm. I assume one button is for gpio00 flashing button, do you know what the other is?
Are the 2 relays for 2 different channels, or are they for double-pole switching of live and neutral?
Are the 2 relays for 2 different channels, or are they for double-pole switching of live and neutral?
- Fri Jun 10, 2016 7:20 am
#48930
One button is for flash, the other is just a second button, forget which IO it is attached to. The two relays are separate, they bring in the AC from the input and turn on/off sockets/lights, whatever attached. There is also a place for a DHT22. Comes with case. Here is the board spec: http://www.electrodragon.com/w/ESP_Relay_Board#Pin_Mapping_and_Wiring
Forgot to mention, I was able to get the esp8266basic firmware flasher to work as well as the NodeMCU firmware flasher. You must have the flash button pressed while powering up the board.
Forgot to mention, I was able to get the esp8266basic firmware flasher to work as well as the NodeMCU firmware flasher. You must have the flash button pressed while powering up the board.
