ESP8266 Community Forum

- Tue Aug 09, 2016 11:38 pm #52609 Every ESP12 as far as I can say have LED connected to GPIO2. I've never seen such strange behavior you've described
Try to:
1. flash original AT firmware into module, boot it up and check, if AT command work (You can also try some wifi scan command just to make sure that wifi part work ok)
2. if this does not work, try different module in Your current HW setup
3. if this work, try to upload simple Blink sketch

- Wed Aug 10, 2016 4:51 am #52622

So what I found was flashing is fine but only if it is powered by the programmer, if I then power it by the 5v through the AMS1117 and only leave the RX and TX connected to the programmer so I can read the serial it does nothing,

just to be clear: you not only leave Tx/Rx connected, I hope gnd too?

- Wed Aug 10, 2016 7:25 am #52628 Yes The blinky did not work though :S

Amazing selection of ESP8266 and ESP32 modules can be found here.

- Mon Aug 15, 2016 10:02 am #52992

So what I found was flashing is fine but only if it is powered by the programmer, if I then power it by the 5v through the AMS1117 and only leave the RX and TX connected to the programmer so I can read the serial it does nothing,

just to be clear: you not only leave Tx/Rx connected, I hope gnd too?

Ok I now have the power coming through a battery that has 2. something into the step up which is providing 3.22 v and same, in serial monitor just garble and the LED flicks on and then that is it, it never connects to my broker, swapping the power to the 3.3 from the serial programmer, this gives 2,92 on first load and is powering ok, this is very confusing. Anyone any ideas, want to get this project boxed off.

Amazing selection of ESP8266 and ESP32 modules can be found here.