- Tue Nov 29, 2016 8:51 am
#58834
What error are you getting ?
Did the upload succeed ?
What is your code ?
Did the upload succeed ?
What is your code ?
- Wed Nov 30, 2016 4:02 am
#58881
First of all thanks for the respond.
What I'm trying to make is that,
I connect to lower panel connector USB cable, in IDE identifies the board as UNO with its COM.
Run the Blink software running, and I do not see that the LED is blinking.
If I connect the cable to the top panel (ESP), I can not find a board to choose,
I tried to choose the ESP's possible, and not able to identify any of them.
Do I need to install a driver for this board?
Thanks.
What I'm trying to make is that,
I connect to lower panel connector USB cable, in IDE identifies the board as UNO with its COM.
Run the Blink software running, and I do not see that the LED is blinking.
If I connect the cable to the top panel (ESP), I can not find a board to choose,
I tried to choose the ESP's possible, and not able to identify any of them.
Do I need to install a driver for this board?
Thanks.
- Sat Dec 17, 2016 3:02 pm
#59615
I had to install the CH341 driver for my Mac from here: http://www.wch.cn/download/CH341SER_MAC_ZIP.html
MosheB wrote:
Do I need to install a driver for this board?
Thanks.
I had to install the CH341 driver for my Mac from here: http://www.wch.cn/download/CH341SER_MAC_ZIP.html
- Wed Dec 21, 2016 8:32 am
#59787
OK Thanks,
Now its work.
Just the RGB LED not work like in this link.
https://blog.the-jedi.co.uk/2016/01/02/wifi-witty-esp12f-board/
Any proposal?
Now its work.
Just the RGB LED not work like in this link.
https://blog.the-jedi.co.uk/2016/01/02/wifi-witty-esp12f-board/
Any proposal?
