- Tue Nov 08, 2016 3:17 am
#57816
I also have the same error, I've even using different os's. Is there any solution to this issue?
Moderator: igrr
- Sun Nov 20, 2016 2:50 pm
#58435
I was having this problem. I went back through the Adafruit tutorial and got it working.
In order to load any program you must first hold the GPIO button on the ESP8266. The red LED should stay on while the button is held. WHILE holding the GPIO button press the RESET button on the ESP8266. Release the RESET button first and then release the GPIO button. The red LED should be glowing at half brightness. You can now upload to the ESP8266 through the Arduino IDE.
Hope it helps!
In order to load any program you must first hold the GPIO button on the ESP8266. The red LED should stay on while the button is held. WHILE holding the GPIO button press the RESET button on the ESP8266. Release the RESET button first and then release the GPIO button. The red LED should be glowing at half brightness. You can now upload to the ESP8266 through the Arduino IDE.
Hope it helps!
- Sun Jan 08, 2017 5:26 pm
#60679
I got the same problem on Linux, I launched Arduino IDE as root and it worked (for Windows you should launch Arduino IDE as admin). It's probably a permission problem.
- Tue Jan 10, 2017 7:20 am
#60785
Hi,
I had the same issue with the nodemcu board.
I installed the CH340 btw. CH341 driver and it works for me.
Maybe it will work for you too?
Tobias
I had the same issue with the nodemcu board.
I installed the CH340 btw. CH341 driver and it works for me.
Maybe it will work for you too?
Tobias
