- Wed Jan 18, 2017 4:08 am
#61174
time() does not return current time. It returns Coordinated Universal Time (UTC), Thursday, 1 January 1970
Moderator: Mmiscool
- Wed Jan 18, 2017 10:01 pm
#61218
hi samie,
Two possible reasons come to mind...
1. you did not allow a period of time to pass between the timesetup() command and the time() command. Not sure what the correct amount of delay is but I use a delay 1000.
2. the other possibility is that the module is not connected to a network that has access to the internet. If the module is in AP mode then it will not have access to an NTP time server.
hope this helps
dwight
Two possible reasons come to mind...
1. you did not allow a period of time to pass between the timesetup() command and the time() command. Not sure what the correct amount of delay is but I use a delay 1000.
2. the other possibility is that the module is not connected to a network that has access to the internet. If the module is in AP mode then it will not have access to an NTP time server.
hope this helps
dwight
