ESP8266 Community Forum

- Wed Dec 10, 2014 5:40 am #4477

Regarding an onboard ldo, I bought this: http://de.aliexpress.com/item/Ultra-sma ... 84781.html

A little bit of overkill, I'd say.
This should also do:
http://www.aliexpress.com/item/RC-Airpl ... 51541.html

- Tue Jan 06, 2015 7:25 am #6441

http://www.aliexpress.com/item/ESP8266- ... 33472.html

I received the board yesterday.
Tried to get the board running with the Android app, but couldn't, because the board comes preconfigured with a password protected AP, and I couldn't find the password anywhere. So I flashed NodeMCU and played around with the LEDs.

The board has:
- ESP-12 module (with blue LED at TX)
- pin headers for all pins of the ESP-12 (standard pitch 0.1")
- 3.3V regulator
- extra 3 pin header for RxD/TxD/GND
- jumper to connect GPIO0 to ground (to enter flashing mode, all other GPIOs are already at the right level via resistors)
- 6 red LEDs
- 1 RGB LED (and spare pads to use 3 0603 LEDs instead)
- a battery holder (3xAA) soldered to the board
- 1 LDR connected to the ADC input

Flashing worked flawlessly (the board comes with the flash mode jumper already installed). I used a CP2104 board for the USB to serial conversion.

I think this is a nice little board to get you started, but still cheap enough to use it in a permanent IoT device.
Just connect some sensors/relays/buttons/LEDs/buzzers/whatever with jumper cables and you have a nice unique solution without soldering a single wire.

- Tue Jan 06, 2015 8:38 am #6448 Thanks for the review!

board comes preconfigured with a password protected AP, and I couldn't find the password anywhere.

Did you try these instructions from the AliEpress listing?

3 Replace the battery, mobile search to a network router AI-THINKER
4 join the router (the router module form) password is: ai-thinker

- Tue Jan 06, 2015 9:30 am #6459 I finally received my ESP12.
Out of curiosity I removed the shielding, and look what I found: a solder bridge between two pins. :/
I have not tested the module yet, I will try to remove the bridge first.

Edit: my second module has the same solder bridge. Is it intended?
Edit2: I removed the image, as both pins are VDD3P3