- Sun Jun 25, 2017 11:17 am
#67593
Here the code:
/*
Blink
Turns on an LED on for one second, then off for one second, repeatedly.
Most Arduinos have an on-board LED you can control. On the Uno and
Leonardo, it is attached to digital pin 13. If you're unsure what
pin the on-board LED is connected to on your Arduino model, check
the documentation at
http://www.arduino.cc This example code is in the public domain.
modified 8 May 2014
by Scott Fitzgerald
*/
// the setup function runs once when you press reset or power the board
void setup() {
Serial.begin(115200);
Serial.println("Blink Test LED");
// initialize digital pin 7 as an output.
pinMode(7, OUTPUT);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(7, HIGH); // turn the LED on (HIGH is the voltage level)
Serial.println("LED High");
delay(1000); // wait for a second
digitalWrite(7, LOW); // turn the LED off by making the voltage LOW
Serial.println("LED Low");
delay(1000); // wait for a second
}
and response while uploading.
Uploading 228464 bytes from C:\Users\Enrique\Documents\Arduino\HEX/Blink.cpp.bin to flash at 0x00000000
................................................................................ [ 35% ]
................................................................................ [ 71% ]
................................................................ [ 100% ]
Thank againg.
