- Mon Jun 26, 2017 12:32 pm
#67639
Hi Team, I am using ESP8266 nodemcu, Arduino IDE 1.8.3, and the BasicOTA example.
After upload the monitor displays:
... so far so good.
As far as I understood the process, this sketch sets up mDNS, but Sniffer just lists ARP as service .... and I do not get the OTA port displayed in Arduino IDE ...
I turned off all firewalls ....
Thanks for help, Markus
Update >> It was the firewall ... I am using a company computer with managed SEP installed. After uninstalling SEP the port showed up -just disabling was not enough- now after reinstalling SEP, the port stays, and can be used after disabling SEP temporarily. There is nothing to do on the fritz box (fritz!box), and nothing to change/add/install with Bonjour.
After upload the monitor displays:
Code: Select all
Booting
Ready
IP address: 192.168.178.20... so far so good.
As far as I understood the process, this sketch sets up mDNS, but Sniffer just lists ARP as service .... and I do not get the OTA port displayed in Arduino IDE ...
I turned off all firewalls ....
Thanks for help, Markus
Update >> It was the firewall ... I am using a company computer with managed SEP installed. After uninstalling SEP the port showed up -just disabling was not enough- now after reinstalling SEP, the port stays, and can be used after disabling SEP temporarily. There is nothing to do on the fritz box (fritz!box), and nothing to change/add/install with Bonjour.
Last edited by MarkusF on Wed Jun 28, 2017 5:16 am, edited 1 time in total.
