ESP8266 Community Forum

- Thu Jul 20, 2017 7:07 pm #68397 So, Arduino pins can be defined by an int variable, but what variable type would I use for the Dx notation of the 8266 in Arduino IDE?

Ex:
int pin = 14;
vs.
??? pin = D7;

Obviously I could just use the Arduino pin numbers, but for convenience it would be nice to use 8266 notation.

- Thu Jul 20, 2017 8:14 pm #68400 I compile with the Generic ESP8266 module selection. When setting up the pin I use the GPIO number of the pin.

Code: Select allconst int voltPin = A0;       //  Only analog pin
const int ledPin =  15;       //  LED pin on GPIO15
const int relayPin = 4;       //  LED pin on GPIO4


If you define your board as a different type, NodeMCU for example, then a Dx number scheme is available. Renumbering port pins so that pins on the board are in sequence.

- Sun Aug 06, 2017 2:38 pm #68882 Pin type is

Code: Select allstatic const uint8_t

See igrr's post here: https://github.com/esp8266/Arduino/issues/584