ESP8266 Community Forum

- Fri Oct 20, 2017 12:35 pm #71023 Do you want to use it in client or access point mode?

Both are possible and for both you can set SSID and password. The "easy" procedure using a web browser only works for client mode. If you want to use access point mode, you will need to telnet to the device and use the wac (wlan-ap-configure) command, then save (cw) then r (reset).

- Fri Oct 20, 2017 12:42 pm #71024 I corrected the binaries of the release. It appears I picked them from the wrong directory.

- Fri Oct 20, 2017 1:46 pm #71025

Do you want to use it in client or access point mode?

Both are possible and for both you can set SSID and password. The "easy" procedure using a web browser only works for client mode. If you want to use access point mode, you will need to telnet to the device and use the wac (wlan-ap-configure) command, then save (cw) then r (reset).

Is this commands in manual are still correct?
I can not find this, what do you wrote now, could you forward here all commands?
A have some problems to put commans in telnet, any asign put in console return unknown command..only ? sign got some result.

- Fri Oct 20, 2017 2:45 pm #71026 to setup Ap send wac "ssid" "pass" nr channel e.g
wac test test 1 correct?