ESP8266 Community Forum

- Fri Oct 20, 2017 3:24 pm #71027

to setup Ap send wac "ssid" "pass" nr channel e.g
wac test test 1 correct?

something wrong with this setup..
i send:
wac test testtest 11, cw,r and i see the network SSID was change, but i can not connect to this network..
Any changing the ssid corresponding to unable to connect..
could you check it?

- Wed Nov 08, 2017 9:44 am #71642

wac test testtest 11, cw,r

???

You sould use

Code: Select allwac test testtest 11

Then you should write the config (cw) and then reset (r).

- Wed Nov 08, 2017 9:51 am #71643

wac test testtest 11, cw,r

???

You sould use

Code: Select allwac test testtest 11

Then you should write the config (cw) and then reset (r).

yes, i send it exactly the same.
wac test testtest 11
cw
r
and impossible to connect to test ssid.

- Wed Nov 08, 2017 1:41 pm #71652 What do you get as reply? Immediately after the wac command?