- Thu Jan 18, 2018 6:30 am
#73255
hello all,i
need some help with mynodemcu OpenMQTTGateway.
actually i have 2 problems:
1-when i first starts my nodemcu it will only connect to broker if i open the serial monitor.
after that i can close serial monitor and it will run fine.
2-after it will connect it will fire the last command was on memory..
so every time it start up it will trigger my rf relay, if i will restart the broker it will send the last rf command also
im using rf to mqtt and mqtt to rf.
can anyone help me with this issue??
need some help with mynodemcu OpenMQTTGateway.
actually i have 2 problems:
1-when i first starts my nodemcu it will only connect to broker if i open the serial monitor.
after that i can close serial monitor and it will run fine.
2-after it will connect it will fire the last command was on memory..
so every time it start up it will trigger my rf relay, if i will restart the broker it will send the last rf command also
im using rf to mqtt and mqtt to rf.
can anyone help me with this issue??
