ESP8266 Community Forum

- Sat Jan 17, 2015 12:41 am #7484 Hi,

I purchased the same board, but I cannot even get it to activate. Can you please help as I am a noob.

Mark

- Sat Jan 17, 2015 9:53 am #7506 hi mputtnam, i'm also a beginer, after power on the module put light on, ou can see wifi light when you connect to his SSID with ai-thinker pass.

Did someone have IOT.APK to make test on android ? a download link help us to make tests

did someone have electric shemas ? for board pin in/out ?

Last edited by Smoky on Mon Jan 19, 2015 11:22 am, edited 1 time in total.

- Sat Jan 17, 2015 1:19 pm #7527 I have just got this board - I tried powering it up - blue and red led lit and large RGB led also lit green and blue. There was no access point created. I removed the jumper from the board and re-booted - now just the little blue (power?) light is on together with the RGB led strongly.

Now I see the access point AI-THINKER_9Fxxxx - I tried to join the network with passwords:
ai-thinker
AI-THINKER
AI-Thinker
AI_THINKER
ai_thinker

Can't join with any of these, but that's ok because I have little interest in the official firmware.

Re-applying the jumper to the top pins puts it into flash mode - and the three pins to one side duplicate the Rx (top) GND centre and Tx (bottom) pin near the RGB led.

I was able to flash it with nodeMCU firmware and it seems to work fine.

Hope this helps.

- Sun Jan 18, 2015 12:38 pm #7628 Does anyone have a schematic for this board? It looks like there is an LED on each GPIO. If you wanted to use it for another application, you might have to desolder some resistors to prevent loading inputs...