Your new topic does not fit any of the above??? Check first. Then post here. Thanks.

Moderator: igrr

User avatar
By ashokraj
#92089 Hi,
I have setup auto programming of ESP12F module with CH340G. The program runs well once i upload program via arduino. As long as board is powered up it runs. But once i recycle the program doesnt run!!

How to solve this issue?

However I have noticed that once i connect the reset to ground, the program runs normally. Everytime there is a recycle in power i do not prefer to do hard reset.

https://drive.google.com/file/d/1kCW1K1uQJ0-ODv3Mv5xdFqboc_Gik1rQ/view?usp=sharing
User avatar
By QuickFix
#92103 Just for convenience (image of TS):
CH340.JPG


I'm sure this is not the entire schematics. :?
What did you do to GPIO2 and GPIO15?
Why did you connect the DTR line to the enable (EN)-pin of the ESP, this should be the reset-pin if you actually want the ESP to reset. :idea:
You do not have the required permissions to view the files attached to this post.