ESP8266 Community Forum

- Sun Dec 21, 2014 6:59 pm #5361 Are you sure that the in-line comment on the line where you're driving
the one-wire pin high-impedance isn't causing your file load utility to
discard that line?

-John

- Wed Dec 24, 2014 3:11 pm #5634

Are you sure that the in-line comment on the line where you're driving
the one-wire pin high-impedance isn't causing your file load utility to
discard that line?

Sorry it took so long, but I tested my upload tool - it's not skipping the line

- Mon Dec 29, 2014 6:09 am #5881 Hi, this is very strange
Have you seen this power consumption table ? https://nurdspace.nl/ESP8266
ESP in deepsleep mode take about 10 mA and in standby mode take only 0.9 uA but standby mode is not implemented in lua api for now...

- Mon Dec 29, 2014 1:42 pm #5905

Hi, this is very strange
Have you seen this power consumption table ? https://nurdspace.nl/ESP8266
ESP in deepsleep mode take about 10 mA and in standby mode take only 0.9 uA but standby mode is not implemented in lua api for now...

I think there is a mistake in the specs - the numbers should be quite oposite - 10mA for standby and 0.9uA for deep sleep.
However, I cannot get to such values.
And, my meter is nowhere near sensitive enough
That's why I asked about the experience of others